How to Cook the Perfect Steak

Crisp and caramelized on the outside, but never burnt. A first bite that melts in your mouth as the savory, perfectly seasoned flavor of beef hits your palate. The rich, smoky aroma of animal fat dripping onto an open fire.

That, my friends, is a perfect steak. You don’t have to make reservations at an expensive steakhouse to reach this sort of steak nirvana. It can be yours any night of week in your own kitchen by following a few simple and painless steps.

Navigating the Meat Case

First things first – you’ve got to buy the steak. To understand the meat case at a butcher shop, you must first understand your cuts of meat. Close your eyes and visualize standing in a field while looking at the side of a cow or steer. The first cut of meat behind the head is the shoulder, known in butchery terms as the chuck. Although flavorful, the often-used shoulder muscle is mostly tough and full of connective tissue. The meat from this section of a cow is less expensive and primarily used for slow-cooked roasts. However, if you’re looking for a bargain, a top blade steak, also called a flatiron, is a flavorful, fairly tender chuck steak to throw on the grill.

Next in the line-up, anatomically speaking, are the portions of a cow that butchers call the rib, short loin and sirloin. The meat from this top, middle area of the cow is the most tender, since the muscles move the least during a cow’s life (as compared to the shoulder, hind end and shank). From these three larger cuts come most of the steaks you see at the market.

Rib Steaks

These steaks are basically a prime rib roast cut into smaller pieces. A rib steak has the bone attached, but the more popular rib eye steak has had the bone removed.

The rib eye is also sold as a Spencer steak (in the West) and Delmonico steak (on the East coast). Rib steaks usually have large pockets of fat, which add flavor and give the steak a moist, juicy texture.

Short Loin Steaks

Some people find a long, narrow and slightly triangular top loin steak to be less tender than a rib eye and miss the extra ripples of fat. Others think a top loin steak has just the right balance of flavor and tenderness, without being too fatty. When it has a bone, a top loin steak is known as a shell steak. When the bone is removed it goes by many names: a strip steak, Kansas City strip, New York strip and sirloin strip steak, (which, confusingly, comes from the short loin, not the sirloin) are all the same cut of steak.

Also cut from the short loin portion of a cow is the tenderloin, a portion of meat considered to be extremely tender (hence the name). Tenderloins are easy to recognize in the meat case, due to a long, cylindrical shape that’s thicker on one end then tapers down. A tenderloin is cut into many different types of steak, and all are pretty pricey. The thickest part (usually about 3 inches thick) of the tenderloin is cut into a steak known as chateaubriand. Filet mignon (also known as tenderloin steak) is cut from the meat behind the chateaubriand and is slightly less thick. Filet Mignon is thought to be the most tender part of the tenderloin, but on the downside, the flavor can be pretty mild.

Last but not least, the short loin gives us the t-bone, a steak named for, you guessed it, a “T” shaped bone that runs down the middle. On one side of the bone is meat from the top loin, and on the other is a thin strip of tenderloin. Some say this steak combines the best of both worlds: the tenderness of a tenderloin steak and the rich, “meaty” flavor of a top loin steak. If you’re really hungry or feeling particularly manly, skip the T-bone and go straight for the porterhouse, which is simply a t-bone steak with a bigger portion of tenderloin attached.

Sirloin Steak

The sirloin is basically the cow’s hip. Sirloin steaks are usually fairly large but thin, and the meat is both moderately flavorful and moderately tender. Steaks from this region of a cow tend to be a good value. The most well-known among them are the top sirloin steak and the tri-tip, both boneless. Lesser-known steaks cut from the sirloin are the pin-bone, flat-bone, round-bone and wedge-bone steaks.

Directly below the loin and sirloin, on the underside of the cow’s belly, is the flank. Flank steak is a thin, wide, boneless cut with a texture (grain) that looks very stringy. Cooked very quickly to medium-rare and sliced thinly against the grain, the chewy texture is less noticeable and you will be rewarded with rich flavor.

Seasoning the Meat

If a high-quality cut of meat is cooked correctly, you really don’t need much more than salt and pepper. Which makes one think that seasoning a steak is a very short topic, until of course, you consider the hotly debated “salt early” and “salt late” theories.

The Salt Early Theory: Salting meat many hours or even days before cooking breaks down the protein in meat and makes it more tender. Initially, the salt draws out moisture, but over time the meat re-absorbs the moisture, which is now flavored with salt and therefore adds more succulent flavor to the meat.

The Salt Late Theory: Salt dries meat out. Period. Don’t add it until immediately before cooking.

In this debate, we take the middle road. In our experience, the salt early theory rings true with larger or tougher cuts of beef. For your average steak, salting about a half-hour before cooking is ideal and seasoning right before cooking works just fine, too.

Before seasoning, always make sure to pat the steak dry. Some people like to brush the steak with oil (avoid olive oil, which can become bitter at high heats) or a combination of melted butter and oil before seasoning to help the outside of the steak brown. Season both sides of the steak, using a teaspoon or less of both salt and pepper. Remember, you can always add more seasoning after the steak cooks, but you can’t un-salt the meat.

After seasoning, let the meat sit on the counter for a bit so it comes up to room temperature (a good rule of thumb is at least 10 minutes for every inch of thickness).

If you want to branch out from salt and pepper, marinades and rubs can be used on any type of steak, but are an especially great way to bring flavor to less-expensive cuts.

Cooking Methods

What we love about cooking steak on the stove is how easy it is to get a crisp, caramelized coating on the outside of the steak without over-cooking the middle. More often than not, this is harder to achieve on a grill. Using a combination of the stove-top and the oven is a tried and true method for perfect steak. The question is, which comes first?

The most common method is searing the steak first on the stove, then finishing it in a hot oven.

• Pat dry and season the steak.
• Pre-heat the oven to 450-500 degrees Fahrenheit.
• When the oven is up to temp, drizzle a little oil in an oven-proof pan (cast iron works great) and then heat the pan on the stove over high heat for several minutes until it just barely starts to smoke (you can give the pan a head start by putting it in the oven while it preheats).
• Drop the steak in the pan and let it sit without touching it for 3 minutes. Be prepared to turn on your fan or open some windows, as there will be smoke.
• If the steak is stuck to the pan, it’s not done browning yet and needs a little more time. If it comes up relatively easily after 3 minutes, flip the steak.
• Put the pan, with the steak in it, in the oven.
• Let it bake for several minutes, then check by temperature or texture for doneness.

A small but vocal population of steak lovers swears by the “reverse sear” technique. The theory behind this method is that cooking the steak in the oven first will dry the outside of the steak while slowly cooking the inside and keeping it tender. If the outside of the steak is dry, it will then sear faster and more efficiently in a hot pan.

• Pat dry and season the steak.
• Preheat the oven to 275 degrees Fahrenheit.
• Place a wire cooling rack on a cookie sheet then put the steak on the cooling rack. This allows hot air to circulate around the entire steak.
• Bake the steak until the internal temperature is 100-110 degrees.
• Drizzle a little oil in a pan over high heat. Just as the pan begins to smoke, drop the steak in the pan.
• Cook the steak for 2 minutes on each side.

So does this method really yield a more perfect steak? We have to admit, it did brown the outside of the steak very nicely while leaving the inside really juicy and tender. As a bonus, you get nice grill marks from baking the meat on the cooling rack. Give it a try, and you be the judge.

In some people’s minds, however, the only way to cook a steak is over an open flame in the great outdoors. Many of these same people consider grilling an art form that cannot be mastered overnight. It takes years of experimenting with different types of grills, different heat levels and cooking times and various seasonings and marinades. This may be true for some fanatics out there, but we feel pretty confident that you’ll get a great steak the first time out if you pay attention to a few key things.

The “charcoal vs gas” debate is one that has gone for decades, and we think they both have their place. For convenience and the easy ability to control heat levels, a gas grill can’t be beat. For depth of flavor, charcoal usually wins out.

Either way, you never want to put a steak on a cold grill. Wait until it heats up. For a gas grill, this is easy. Simply turn the knob to medium-high and keep the lid closed for 10-15 minutes. For a charcoal grill, the type of charcoal you use will affect the heat level as well as the flavor of the meat. Briquettes are easy to light, hold steady heat and are inexpensive, but they are also made with questionable additives that can give meat a chemical flavor. We favor hardwood charcoal (made from oak, hickory, mesquite, etc) for a natural, smoky flavor. Hardwood charcoal can be a little trickier to light and once it gets going it burns hotter and more unpredictably, which requires keeping a closer eye on the grill. A small price to pay, we think.

There is no point in using hardwood charcoal and then dousing it in lighter fluid, which will make your meat taste like it was marinated in petroleum. Instead, use a charcoal chimney starter to stack and light the coals. Once the coals are lit (usually about 30 coals are needed to provide adequate heat) wait until they change from bright red to an ashy white, which usually takes at least 20 minutes. Spread the coals out, placing most of them on one side to create a high heat side and a few on the other side of the grill to create a low heat side. Cover the grill for about five minutes so the heat builds to medium-high. To test the heat, simply hold your hand a few inches above the grill. If you can’t hold it there for more then 2 seconds, you’ve got high heat. If you can hold it there for 4-6 seconds without pulling away, the heat is medium-high.

Now, you’re ready to cook. Start by placing the steak (patted dry, seasoned and close to room temp.) over medium-high heat for at least 3 minutes without turning. This is about right for a 1-inch steak; thicker steaks will need another minute or two. Flip, and grill the other side for another 3 minutes. This should brown both sides and bring the steak to the brink of medium-rare.

To bring the steak up to desired doneness, move it to an area of the grill that has less-intense heat. Close the lid and cook for another 3-5 minutes before checking if it’s ready.

Although flames add excitement to grilling, they do nothing for the meat but burn it. Move the steak away from flare-ups as soon as they occur. In general, try to move the steak as little as possible while it cooks – too much movement prevents the steak from searing and getting a crispy, brown coating.

Is It Perfect Yet?

A thermometer is the most accurate way to gauge if steak is done to your liking. Although your thermometer will probably tell you that 145 degrees is rare for beef, any chef you ask will tell you differently. Rare in a chef’s mind, meaning very pink, is closer to 125 degrees; medium-rare is 125-130; medium, 130-135 degrees; medium-well, 135 to 140 degrees; and well, 140 and above. You can also give the steak a poke with your finger. Rare is squishy, medium-rare is spongy, and medium-well is taut. The steak will continue to cook at least five degrees when it’s off the grill or out of the pan, so err on the side of taking it away from heat earlier rather than later.

The final step, which should be included no matter how you cook your steak, is letting the meat rest before cutting into it. As the meat cools down the proteins begin to firm up and hold moisture, so when you cut into the steak all the juicy goodness won’t run out. About 8-10 minutes should do it, and a loose cover of foil or no cover at all is a much better choice than tightly sealing the meat up while it rests. If you’re like us, it takes at least 8-10 minutes to set the table and get everyone to sit down, so usually this step simply happens without having to think about it.

Hungry yet? Get over to your local butcher shop, grab a little salt and pepper, and give one of these cooking methods a try. In less time than it takes to drive to a restaurant, you’ll be sitting down at your kitchen table with a tender, sizzling hot, and dare we stay it, perfect steak on your plate.

This article was brought to you with one of the Challenge #1 (below) mini-challenges in mind. Commit to cooking your own food this month, and check back each Saturday for more Primal cooking tutorials.

Grab The Primal Blueprint Cookbook Today and Receive Free S&H and a Free Primal Blueprint Poster

Posted By: Worker Bee

94